A Metal Bunk With a Storage Wall

The Valren bunk bed is the storage version of this twin XL over twin XL metal frame, drawn so one end carries a wall of functions rather than a plain post. Square steel tube posts stand at all four corners, carrying a steel slat deck on each level so a twin XL mattress goes down without a box spring above or below. At one end, a perforated steel pegboard fills the panel between the two bunks, a hanging rod spans the space behind it for shirts and bags, and two drawers glide out at floor level on metal runners. A shelf sits beside the upper bunk at pillow height, and a second shelf spans the lower bunk headboard. A ladder climbs the opposite end, and guardrails enclose the upper bunk along both long sides.

FEATURES

• Hanging Rod Below the Upper Bunk spans the end of the frame for shirts, jackets and bags, giving a room with no closet somewhere to hang the things that cannot be folded
• Perforated Steel Pegboard fills the end panel for hooks, baskets and small shelves, so the wall of the bed carries whatever the room needs it to carry
• Two Base Drawers glide out at floor level on metal runners, swallowing folded clothes, bedding and the things that would otherwise stack in a corner
• Headboard Shelf on Each Level sits at pillow height on both bunks for a phone, glasses and a water glass, so the top sleeper stops climbing down for what was left behind
• Twin XL Sleep Decks carry mattresses five inches longer than a standard twin on both levels, so a taller sleeper stops meeting the footboard before morning
• Steel Slat Deck supports the mattress directly on each level, so no box spring is needed above or below and air moves freely under both mattresses
• Full-Length Top Guardrails enclose both long sides of the upper bunk along the whole sleeping surface rather than stopping partway toward the foot
• Square Steel Tube Frame carries the posts and rails in square-section steel, holding the shelves, the drawers and both sleeping decks square through years of daily use
• Dorm-Ready Compact Footprint keeps the frame under 42 inches wide on a mattress size most campus rooms already supply, putting sleeping, hanging and storage into one footprint

Materials

• Frame and Posts: Steel
• Surface Finish: Powder-Coated
• Slats: Steel
• Guardrails: Steel
• Ladder: Steel
• Pegboard: Perforated Steel
• Hanging Rod: Steel
• Shelves: Engineered Wood
• Drawer Boxes: Engineered Wood
• Drawer Runners: Metal
• Hardware: Metal

Care Instructions

• Wipe the steel frame with a soft damp cloth and dry it right away
• Avoid abrasive powders, scouring pads, bleach and solvent-based cleaners on the coating
• Wipe the shelves and drawer fronts with a barely damp cloth and dry immediately
• Dust the pegboard with a dry cloth and lift any hooks clear when wiping behind it
• Wipe the drawer runners with a dry cloth and clear grit so they keep gliding smoothly
• Close both drawers fully before moving the frame or stripping the lower bunk
• Clear the headboard shelves before changing the sheets so nothing gets knocked off
• Touch up any chip in the coating so bare steel does not sit exposed to damp
• Retighten every bolt after the first two weeks of use, then check them every few months