A Fluted Storage Bed That Lifts

The Roros king storage bed is made for the bedroom that wants hidden storage without an upholstered frame. Every visible surface is a fluted panel, a row of vertical reeds with a wood-grain finish, set across the wide headboard and around all four sides of the base, so the bed looks finished from the foot and both sides as well as the front. The base corners are rounded rather than square. Lift the foot end and the slatted platform rises on gas struts over a steel frame, opening a storage compartment under the mattress for bedding, luggage and out-of-season clothes. The king mattress rests on arched wood slats flush with the outer edge of the base, so no box spring is needed. With no fabric anywhere, the whole frame wipes clean with a damp cloth.

Features

• Fluted on Every Side with vertical reeds across the headboard and all four sides of the base, so the bed looks finished from the foot and both sides
• No Fabric to Clean on any part of the frame, so the wood-grain panels wipe down with a damp cloth and give dust and pet hair nothing to cling to
• Gas Lift Storage Base that raises the slatted platform from the foot end and holds it open, with room below for bedding, luggage and seasonal clothes
• Wide Panel Headboard that extends a little past the base on both sides, framing the pillows and leaving space for nightstands set close to the bed
• Mattress Sits Flush with the outer edge of the base, so there is no raised rail around the mattress and the bed reads as one clean block
• No Box Spring Needed with twelve arched wood slats on a steel frame that hold a king mattress directly and lift with the platform
• Oak-Tone or Walnut-Tone wood-grain finish on the same fluted frame, light and natural for a bright room or deep and warm for a moodier one
• 1,000-Pound Weight Capacity for two sleepers and a king mattress together, carried by the steel lift frame and the arched slats
• Primary Bedroom King sized for a main bedroom with a long wall, where the fluted headboard sets the tone for the furniture around it

Materials

• Panels: Engineered Wood with Fluted Wood-Grain Finish
• Wood-Grain Finish: Oak-Tone (oak variant) or Walnut-Tone (walnut variant)
• Frame and Lift Platform: Steel
• Lift Mechanism: Gas Struts
• Mattress Support: Arched Wood Slats
• Hardware: Metal

Care Instructions

• Place the mattress on the platform before using the lift; the gas struts are balanced for a mattress’s weight, and an empty platform can rise quickly
• Keep hands and items clear of the hinge and the storage edge when lowering the platform
• Pack stored items below the top of the base so the platform closes flat
• Wipe the fluted panels with a soft, slightly damp cloth, then dry them
• Use a soft, dry brush to lift dust from the grooves between the reeds
• Do not let water stand on the panels or the base edge, since the engineered wood under the finish can swell if moisture gets in through a chip
• Avoid abrasive pads and harsh cleaners, which can wear the wood-grain finish
• Keep the bed out of long periods of direct sunlight to limit fading of the finish
• Use standard king sheets sized for 76" × 80"; California King sheets will not fit
• Check and tighten the frame bolts, headboard brackets and gas strut fittings every few months
• The larger carton weighs close to one hundred pounds; carry it with two people and assemble the bed in the room where it will stay