A Small Dresser Built for Short Walls

The Roros fluted 3-drawer dresser is made for the bedroom where a full-width dresser will not fit. At just under three feet wide, it fits a short wall, the space between a window and a door, or the side of the bed, where it works as a nightstand with room for clothes. Each of its three drawers carries vertical reeds in a wood-grain finish and a small gold-tone pull, and each front is cut with a soft arc along its lower edge, so the gaps between drawers curve instead of lying straight. The drawers travel on metal side slides. A smooth top with rounded corners holds a lamp and a few books, and four tapered wood legs lift the case off the floor.

Features

• Fluted Drawer Fronts with vertical reeds in a wood-grain finish across all three drawers, matching the Roros fluted beds, dresser and sideboard
• Arched Lower Edges cut into each drawer front, so the gaps between drawers curve gently instead of lying straight across the chest
• Three Wide Drawers each nearly two and a half feet across inside, with room for folded sweaters, jeans and spare linens laid flat
• Metal Drawer Slides on every drawer that carry it out smoothly and keep it level as it fills with clothes and linens
• Gold-Tone Pulls centered at the top of each drawer, small enough to keep the reeds in view and easy to grip with one hand
• Tapered Wood Legs that angle slightly outward and end in floor glides, lifting the case off the floor in a mid-century stance
• Smooth Rounded Top with a flat surface and softened corners, holding a lamp, a clock or a few books level and wiping clean with a cloth
• 100-Pound Top Capacity with weight spread evenly across the top, while each of the three drawers is rated for twenty-two pounds of folded clothes or linens
• Small Bedroom Chest just under three feet wide, fitting a short wall, the space under a window or the side of the bed as a large nightstand

Materials

• Case and Drawers: Engineered Wood
• Fluted Fronts: Engineered Wood with Fluted Wood-Grain Finish
• Wood-Grain Finish: Oak-Tone (oak variant) or Walnut-Tone (walnut variant)
• Legs: Wood with Floor Glides
• Drawer Slides: Metal
• Handles: Metal
• Hardware: Metal

Care Instructions

• Secure the dresser to the wall with an anti-tip kit before filling the drawers
• Load the bottom drawer first and avoid opening more than one drawer at a time
• Keep each drawer within its twenty-two-pound rating and the top within one hundred pounds, spread evenly
• Wipe the top and fronts with a soft, slightly damp cloth, then dry them right away
• Do not let water stand on the top or along the edges, since the engineered wood under the finish can swell if moisture gets in through a chip
• Use a soft, dry brush to lift dust from the grooves between the reeds
• Use coasters and place a mat under lamps or decor that could scratch the finish
• Avoid abrasive pads and harsh cleaners, which can wear the wood-grain finish
• Check and tighten the legs, drawer slides and handles every few months
• Lift the dresser rather than dragging it, so the legs do not loosen or twist