A Dining Chair Drawn in Rolls

The Neman dining chairs arrive as a coordinated pair, each built on a solid wood frame of turned round members. Two padded rolls span the full width between the rear posts, one above the other, with an open gap left between them rather than a panel closing the back. The lower roll sits just above the seat and meets the base of the spine, while the upper one clears the shoulder blades, so nothing presses across the middle of the back. Each arm leaves the rear post at roll height, sweeps down toward the front and carries past its support post to a rounded tip. Below, the seat is upholstered in a woven fabric and set into a solid wood apron, and the legs taper as they descend to a small non-slip cap at each foot.

Features

• Double Roll Back stacks two padded rolls between the rear posts and leaves the middle open, so the back reads as two lines rather than one closed panel
• Cantilevered Arm Tips carry past the post that supports them and finish in a rounded end that hangs free, giving each arm a longer line than its structure needs
• Woven Fabric Upholstery covers the seat and both rolls in the same textured weave, holding a soft surface against the smooth turned wood around it
• Solid Wood Apron frames the seat on all four sides so the cushion sits down inside the frame instead of resting on top of it
• Tapered Round Legs narrow as they descend from the apron, ending in a small non-slip cap that keeps the frame level on hard floors
• Metal Pin Detail sits flush in each rear post where the rolls meet the frame, a visible fixing point rather than a concealed joint
• Low Overall Height keeps the whole chair under the level of most tabletops, so a pair reads as part of the table rather than as two separate objects
• 300-Pound Seat Capacity per chair for confident everyday adult seating across the pair
• Apartment Dining Footprint suits breakfast nooks, small dining rooms and studio corners where a low profile keeps the space feeling open

Materials

• Seat and Roll Upholstery: Woven Fabric
• Frame, Arms and Legs: Solid Rubberwood
• Wood Finish: Sealed
• Post Fixing: Metal Pin
• Floor Glides: Non-Slip Caps
• Hardware: Metal

Care Instructions

• Vacuum the seat and both rolls weekly with a soft brush attachment to lift dust before it settles into the weave
• Blot spills immediately with a dry cloth, pressing straight down rather than wiping across the surface
• Spot-clean marks with a cloth lightly dampened in mild upholstery cleaner, blotting rather than rubbing so the weave is not pulled
• Test any cleaner on a hidden section of the seat first, and let the fabric dry fully before use
• Work the brush along the seam where the seat meets the apron, since that channel collects crumbs faster than the open surfaces
• Wipe the wood frame with a soft dry cloth, avoiding harsh chemicals and household cleaners that can lift the sealed finish
• Blot spills off the wood promptly, since the sealed finish takes up standing moisture at the grain
• Keep the chairs indoors, as the sealed rubberwood is not finished for outdoor exposure
• Keep the chairs out of prolonged direct sunlight to protect both the upholstery and the wood
• Check the joints and the post pins every few months and retighten by hand rather than with a power driver