A Solid Wood Chair That Holds Square

The Mogan dining chairs arrive as a coordinated pair, each cut from FAS-grade North American hardwood through the legs, the seat, the uprights and the back. A curved backrest spans between two uprights at shoulder height, its face shaped to follow the spine and its ends rounded where a hand takes hold to pull the chair out. The seat is a single panel dished toward the centre and eased at every edge, carrying the grain across the surface under a clear lacquer that leaves the figure visible. Beneath it, four tapered legs splay outward and cross into a brace that ties each leg to the one opposite, the joint that keeps a wooden chair square through years of pulling in and pushing back. Armless and just under twenty inches wide, each chair pushes fully under a dining table.

Features

• Solid Hardwood Throughout cuts the legs, seat, uprights and back from FAS-grade North American timber, with no veneer laid over board anywhere in the frame
• Cross Brace Under Seat ties all four legs to each other beneath the seat panel, the joint that stops a wooden chair working loose and starting to rock after a year of use
• Curved Floating Backrest spans between two uprights at shoulder height with a shaped face that follows the spine, leaving the small of the back open rather than pressed flat
• Dished Solid Seat shapes the sitting surface into the wood itself with a hollow toward the centre and eased edges, holding position without a cushion to flatten or stain
• Clear Lacquer Finish seals the surface while leaving the grain and figure visible, wiping down after a meal without a fabric to absorb what gets spilled
• Rounded Back Grip finishes both ends of the backrest in a smooth curve, giving a hand somewhere to take hold when the chair pulls out from the table
• Armless Slim Profile keeps each chair narrow enough to push fully under the table, so a pair closes up without overlapping at a corner
• Coordinated Set of Two drops a matching pair into dining rooms, kitchens and apartment eating corners in one purchase

Materials

• Seat, Legs and Frame: Solid Hardwood
• Backrest: Solid Hardwood
• Finish: Clear Lacquer
• Foot Caps: Non-Slip Caps
• Hardware: Metal

Care Instructions

• Dust with a soft dry cloth, following the grain rather than working across it
• Wipe with a barely damp cloth and dry immediately so water does not sit on the lacquer
• Blot spills as they happen rather than letting liquid stand along the seat edge
• Avoid abrasive powders, scouring pads, bleach and solvent-based cleaners on any surface
• Keep the chairs away from radiators, heat vents and long hours of direct sunlight, which dry and fade the timber
• Use a coaster or mat if the chair doubles as a side surface, and lift hot items clear of the finish
• Keep the foot caps clear of grit, and lift rather than drag the chairs when repositioning them
• Check and retighten the leg and brace bolts every few months to keep the frame square