A Metal Frame Drawn in Line

The Kariba dining chairs arrive as a coordinated pair, each built from tapered metal tube in a bronze-tone finish that carries every part of the structure. From the rear posts an arm bends forward and around each side, holding a wrapped section partway along where a hand rests, then meeting the front leg without a bracket between them. Above the seat, a rounded back panel is upholstered on both faces and held between the two rear posts, sitting clear of the cushion below with open space underneath it. The seat is a deep foam cushion set inside the frame, its front edge rounded across the full width. Four legs taper toward the floor and carry non-slip caps at each tip. Nothing in the frame is boxed in, so the chair reads as an outline with two upholstered panels inside it.

Features

• Fabric-Wrapped Arm Section covers only the length where a hand comes down, leaving bare metal ahead of it and behind it rather than upholstering the whole arm
• Rounded Floating Back Panel sits between the two rear posts with open space beneath, upholstered on both faces so the back reads finished from either side of the room
• Tapered Metal Tube Frame narrows toward the floor on every leg, carrying the arms, back and seat on one continuous structure with no visible brackets at the joints
• Bronze-Tone Finish covers the frame in a warm dark tone that sits between black and brass, catching light along the curve of each tube
• Deep Foam Seat Cushion packs the seat thick over the frame and holds its shape under weight rather than settling into a dip through daily meals
• Woven Fabric Upholstery wraps the seat, the back panel and the arm section in a two-tone flat weave that stays matte against the metal
• Open Frame Construction leaves every side of the chair unboxed, so the pair takes up visual space without closing off sightlines across a small dining room
• 400-Pound Weight Capacity per chair carries adult seating well above what a frame this slender suggests, across both chairs in the pair
• Coordinated Set of Two drops a matching pair into dining rooms, eat-in kitchens and home office corners in one purchase

Materials

• Seat, Back Panel and Arm Wrap Upholstery: Woven Fabric
• Cushion Fill: High-Density Foam
• Frame, Arms and Legs: Metal Tube
• Frame Finish: Bronze-Tone
• Floor Caps: Non-Slip Pads
• Hardware: Metal

Care Instructions

• Vacuum the woven fabric regularly with a soft brush attachment to lift dust before it settles into the weave
• Spot-clean marks with a cloth dampened in mild upholstery cleaner, blotting rather than rubbing along the direction of the weave
• Test any cleaner on a hidden section of the seat first, and let the fabric dry fully before use
• Pay attention to the wrapped arm section, which takes hand contact daily and marks sooner than the seat
• Blot spills promptly rather than letting moisture settle where the upholstery meets the metal tube
• Keep the chairs out of prolonged direct sunlight to preserve the upholstery across both variants
• Wipe the metal frame with a soft dry cloth, drying immediately if any moisture reaches it
• Avoid abrasive pads and solvent cleaners on the frame, which can mark the finish
• Check the floor caps are clear of grit and retighten the frame hardware every few months