A Velvet Bed Shaped, Not Tufted

The Boras king platform bed is made for the bedroom that wants a soft bed without tufts, buttons or channels breaking up the fabric. The headboard is one wide, smooth cushion covered in velvet, padded thick and stretching across the full width of the bed, with its top corners flaring outward like a pair of shallow wings. Below, the base is upholstered on all four sides, and its walls slope outward as they reach the floor, so the frame is narrow at the mattress edge and broad at the bottom. Clean seams mark each panel. Twenty-four pine slats clip into a steel center rail on adjustable feet, carrying a king mattress without a box spring, and the velvet upholstery comes off for cleaning.

Features

• Flared Cushion Headboard padded thick and spanning the full width of the bed, with top corners that turn outward like a pair of shallow wings
• Smooth Tailored Velvet with no tufting, buttons or channels, so the headboard and base read as clean, unbroken panels of soft fabric
• Sloped Upholstered Base with walls that angle outward toward the floor on every side, narrow at the mattress and broad where it meets the ground
• Fully Upholstered Surround that wraps the mattress on all four sides in velvet, so the bed looks finished from the foot and both sides
• Pine Slats on Steel with twenty-four pine slats clipped into a steel center rail and set close together, holding a king mattress without a box spring
• Adjustable Center Feet with threaded bases under the steel rail that screw up or down to meet the floor, so the middle of the bed stays supported
• Removable Velvet Upholstery that comes off the frame for cleaning, so a spill on the headboard or base can be handled away from the bed
• 1,000-Pound Weight Capacity for two sleepers and a king mattress together, carried by the pine structure, the steel center rail and its feet
• Primary Suite Statement for a spacious room styled clean and calm, where one smooth velvet form nearly eight feet wide anchors the wall

Materials

• Upholstery: Velvet
• Padding: Cotton Fill
• Frame: Pine Structure
• Slats: Pine on Steel Center Rail
• Legs: Wood
• Center Support Feet: Metal, Adjustable

Care Instructions

• Velvet pile lies in one direction, so the headboard and base can look lighter or darker from different angles; this shading is normal for velvet, not a defect
• Pressed or shaded areas brush back out with a soft clothes brush stroked in one direction
• Creases from compressed packaging are normal after unboxing; pat the fabric smooth by hand, and for stubborn creases hold a garment steamer a few inches away on low
• Vacuum with a soft brush attachment, working in the direction of the pile
• Spot clean with a mild water-based upholstery cleaner, blotting rather than rubbing, and test a hidden area first
• Remove the upholstery for a deeper clean according to the care label, and let it dry fully before fitting it back on the frame
• Black velvet shows lint and dust more readily; a lint roller or soft brush keeps the surface even
• Keep the bed out of long periods of direct sunlight to limit fading
• Adjust the center support feet so each one touches the floor, and recheck them after moving the bed
• Use standard king sheets sized for 76" × 80"; California King sheets will not fit
• Check and tighten the frame bolts and slat fasteners every few months
• The larger carton weighs close to one hundred fifty pounds; carry it with two people and assemble the bed in the room where it will stay