A Dining Chair Set of Six

The Amalfi dining chairs arrive as a coordinated set of six, each built around one continuous upholstered shell rather than a seat bolted to a separate back. The shell curves up from a widened seat into a backrest that draws inward at the sides, with a single seam tracing the line where the two meet. Faux suede wraps the whole shell over foam padding, its brushed nap reading matte and slightly mottled across the curve, deepening in tone where the surface turns away from the light. Four tapered metal legs splay outward from beneath the seat in a powder-coated finish, each ending in an adjustable foot that threads up or down to steady the chair on tile or hardwood. Armless and compact at just over nineteen inches wide, each chair pushes fully under a table between meals.

Features

• One-Piece Curved Shell carries the seat and backrest as a single upholstered form, so the back follows the sitter down into the seat without a joint across the spine
• Widened Curved Seat broadens the seat pan and dishes it slightly toward the centre, holding position through a long meal rather than sliding forward on a flat pad
• Brushed Faux Suede wraps the shell in a matte nap that absorbs light rather than reflecting it, reading warm and softly mottled against a powder-coated base
• Tapered Metal Legs splay outward beneath the seat in a powder-coated finish, planting the chair wide at floor level under a compact upholstered shell
• Adjustable Non-Slip Feet thread up or down at each leg tip to level the chair on tile, hardwood or laminate and stop it rocking mid-meal
• Foam Padded Shell cushions the seat and back through one continuous layer, giving under weight without the shell edge pressing through the upholstery
• Armless Slim Profile keeps each chair narrow enough to push fully under the table, so six seats close up without overlapping at the corners
• Coordinated Set of Six fills a full six-seat table in one purchase with matched upholstery and finish across every chair

Materials

• Seat and Back Upholstery: Faux Suede
• Shell Fill: Foam Padding
• Shell Structure: Engineered Wood
• Legs: Powder-Coated Metal
• Foot Caps: Adjustable Non-Slip Caps
• Hardware: Metal

Care Instructions

• Brush the faux suede regularly with a soft dry brush, drawing in one direction to keep the nap lying evenly
• Vacuum with a soft brush attachment on low suction to lift crumbs and dust out of the nap
• Spot-clean with a barely dampened cloth, blotting rather than rubbing so the nap is not flattened
• Let any damp area dry fully at room temperature before sitting, and never soak the upholstery
• Keep the faux suede away from hair dryers, heaters and radiators, which stiffen the fibres
• Keep the chairs out of prolonged direct sunlight, which fades the nap over time
• Wipe the powder-coated legs with a soft dry cloth, avoiding abrasive pads on the finish
• Turn the adjustable feet to re-level a chair if it begins to rock on an uneven floor
• Keep the foot caps clear of grit, and lift rather than drag the chairs when repositioning them
• Check and retighten the leg bolts every few months across all six chairs