A Dining Chair Set of Four

The Amalfi dining chairs arrive as a coordinated set of four, each built around one continuous upholstered shell rather than a seat bolted to a separate back. The shell curves up from a widened seat into a backrest that draws inward at the sides, with a single seam tracing the line where the two meet and a piped edge finishing the outer rim. Faux leather wraps the whole shell over foam padding, taking a damp cloth after a meal without the absorption a woven fabric brings to a dining table. Four tapered metal legs splay outward from beneath the seat in a powder-coated finish, each ending in an adjustable foot that threads up or down to steady the chair on tile or hardwood. Armless and compact at just over nineteen inches wide, each chair pushes fully under a table between meals.

Features

• One-Piece Curved Shell carries the seat and backrest as a single upholstered form, so the back follows the sitter down into the seat without a joint across the spine
• Widened Curved Seat broadens the seat pan and dishes it slightly toward the centre, holding position through a long meal rather than sliding forward on a flat pad
• Wipe-Clean Faux Leather takes a damp cloth after a meal instead of absorbing what gets spilled, the practical case for leather over fabric at a dining table
• Tapered Metal Legs splay outward beneath the seat in a powder-coated finish, planting the chair wide at floor level under a compact upholstered shell
• Adjustable Non-Slip Feet thread up or down at each leg tip to level the chair on tile, hardwood or laminate and stop it rocking mid-meal
• Foam Padded Shell cushions the seat and back through one continuous layer, giving under weight without the shell edge pressing through the upholstery
• Armless Slim Profile keeps each chair narrow enough to push fully under the table, so four seats close up without overlapping at the corners
• Coordinated Set of Four fills a standard four-seat table in one purchase with matched upholstery and finish across every chair

Materials

• Seat and Back Upholstery: Faux Leather
• Shell Fill: Foam Padding
• Shell Structure: Engineered Wood
• Legs: Powder-Coated Metal
• Foot Caps: Adjustable Non-Slip Caps
• Hardware: Metal

Care Instructions

• Wipe the faux leather with a soft damp cloth and a leather-safe cleaner, testing on a hidden area first
• Blot spills promptly with a clean dry cloth so moisture does not settle into the piped seam
• Avoid harsh chemicals, abrasive pads and solvent-based cleaners, which can dull or crack the faux leather
• Keep the chairs out of prolonged direct sunlight, which dries and fades the upholstery over time
• Wipe the powder-coated legs with a soft dry cloth, avoiding abrasive pads on the finish
• Turn the adjustable feet to re-level a chair if it begins to rock on an uneven floor
• Keep the foot caps clear of grit, and lift rather than drag the chairs when repositioning them
• Check and retighten the leg bolts every few months across all four chairs