A Dining Armchair On Curves

The Morava dining armchairs arrive as a coordinated pair, each built from square steel tubing that replaces four legs with two curved side frames. Every side is drawn from one continuous length: the tube travels forward along the arm, turns down at the front, and sweeps back into a half-round that carries the chair on the floor. A padded seat sits between the two frames, and a separate back cushion mounts above it on two short uprights, leaving an open gap between the two upholstered pieces that reads through from front to back. Woven upholstery covers both cushions in a matte flat weave. The frame carries a powder-coated finish across every face. With the arms set above the height of most table edges, these chairs stand out from the table rather than sliding under it.

Features

• Half-Round Steel Side Frames replace four legs with two curved lengths of square tubing, meeting the floor along an arc rather than at separate points
• Continuous Tube Construction draws each side from a single piece that carries the arm, turns at the front, and sweeps back to become the base
• Open Frame Silhouette leaves daylight passing between the seat, the back cushion and the tubing, keeping visual weight low around a dining table
• Separately Mounted Back Cushion rises on two short uprights behind the seat with a gap left between the two upholstered pieces
• Powder-Coated Steel Finish covers every face of the tubing in a matte surface that wipes clean and resists marking from chair contact
• Padded Seat and Back Cushions wrap foam in a woven upholstery across both surfaces for a soft face against a hard frame
• Arms Above Table Height hold these chairs out from the table edge rather than tucking underneath, so the curved frames stay visible in the room
• Holds Steady to 265 Pounds per chair for confident everyday adult seating
• Coordinated Set of Two drops a matching pair into kitchens, dining rooms and apartment eating corners in one purchase

Materials

• Seat and Back Upholstery: Woven Fabric
• Cushion Fill: Foam
• Frame and Base: Powder-Coated Steel
• Floor Contacts: Non-Slip Pads
• Hardware: Metal

Care Instructions

• Vacuum the upholstery weekly with a soft brush attachment, working across the weave rather than pressing into it
• Blot spills immediately with a clean dry cloth rather than rubbing them into the fabric
• Spot-clean with a cloth lightly dampened in a fabric-safe cleaner, testing on a hidden section first
• Work a soft cloth into the gap between the seat and the back cushion, where dust settles out of sight
• Wipe the powder-coated frame with a soft damp cloth and dry it immediately to prevent water spotting
• Avoid abrasive pads and harsh cleaners on the powder coating, since a break in the finish exposes the steel beneath it
• Touch up any chip in the coating promptly to keep moisture off the bare metal
• Keep the chairs out of prolonged direct sunlight to preserve the upholstery color
• Check the frame fixings every few months, particularly where the back cushion mounts to the uprights
• Lift rather than drag each chair when repositioning, since the curved base contacts the floor along its full length