A Round Table Made for Four

The Kova round dining table is sized for four people at a time, the everyday table for a kitchen, a dining nook or an open-plan corner. The top is engineered wood under a textured wood-grain finish that carries the grain as a raised surface, so it catches the light and reads under your fingertips rather than lying flat like a print. Underneath, the edge is beveled back, which keeps the rim looking slim from the side. The top comes in two halves joined below by steel rails, and four square steel legs in a black powder-coated finish cross under the center and angle out toward the floor. Because the feet land on the diagonals, the space between each pair of legs stays open for a chair.

Features

• Textured Wood-Grain Top with the grain raised into the surface, so it catches the light and has a feel under your hand instead of reading as a flat print
• Beveled Underside Edge cut back at an angle around the full circle, which keeps the rim looking slim from a seated height
• Seats Four Around the table with a clear space between each pair of legs, so every chair slides straight in without meeting a leg
• Angled Square Steel Legs that cross beneath the center and spread toward the floor, set wide under the top for a broad stance
• Matte Black Powder-Coated Base with a fine textured finish on every leg, a quiet contrast to the oak-tone or walnut-tone top
• Two-Panel Tabletop that meets across the middle and is joined underneath by steel rails and bolted plates so the halves sit level
• Oak-Tone or Walnut-Tone finish on the same table, with the oak-tone reading light and knotty and the walnut-tone reading dark and warm
• Floor Glides Under Each Leg where the steel meets the floor, sitting between the base and hardwood, tile or a rug
• Dining Nook Footprint just under four feet across, filling a kitchen corner, a breakfast nook or a small dining room around four chairs

Materials

• Tabletop: Engineered Wood with Textured Wood-Grain Finish (oak-tone or walnut-tone)
• Tabletop Construction: Two Panels Joined with Steel Rails
• Legs: Steel
• Leg Finish: Black Powder-Coated
• Feet: Floor Glides
• Hardware: Metal

Care Instructions

• Wipe the top with a soft, damp cloth, then dry it right away
• Do not let water stand on the tabletop, because the board under the surface swells if moisture gets in through a chip or the center seam
• Wipe up spills near the center seam first, since that is where liquid can reach the board edge
• A soft brush helps lift crumbs from the textured grain before wiping
• Use coasters and trivets under hot dishes, wet glasses and pans
• Avoid abrasive pads and harsh cleaners, which can wear down the textured finish
• Wipe the steel legs with a dry cloth
• Check and tighten the bolts under the top and at the legs every few months
• Lift the table rather than dragging it, so the legs and glides do not twist